RRSPORT.CO.UK

    Forum   Gallery   Shop   Sponsors
Home > Faults & Fixes > Normal Suspension height fault codes
Post Reply  Down to end
Page 1 of 1
 
Highside



Member Since: 03 Oct 2015
Location: Wirral
Posts: 7

United Kingdom 2005 Range Rover Sport Supercharged Java Black
Normal Suspension height fault codes

I have a suspension fault which I need some help with.

I've invested in a 'IIDTool BT' and have some fault codes which I'm hoping you can help me with........

First off, the compressor isn't operating, I've checked the relay and it's being powered and there is 12V across the contact also.
I've measured at the compressor connector and on start up the power is applied until the fault is detected.
I know it sounds obvious that it's the compressor that's failed but I replaced it in the last 2 years so just want to verify that there isn't some control logic preventing it from running.

If there is power to the relay as above does that negate the pressure switch, valves etc?







Thanks in advance for any help

Rob

Post #543783 Wed Dec 20 2017 4:22pm
View user's profile Send private message View poster's gallery Reply with quote
Scrumpy



Member Since: 11 Nov 2016
Location: Surrey
Posts: 567

United Kingdom 

Hi Rob,

might not be much help but as you have the IID tool have you updated the compressor software?

It's easy to do and you never know, it could (if you're lucky) fix your faults.

Good luck 2016 RRS SVR Estoril Blue
2005 4.2L Supercharged Java Black - gone but was my first love.
--------------------------------------------------------------------------------------------------------

If we all point our RR's in the same direction and accelerate at the same time can we turn back time?

Post #543785 Wed Dec 20 2017 4:44pm
View user's profile Send private message View poster's gallery Reply with quote
Highside



Member Since: 03 Oct 2015
Location: Wirral
Posts: 7

United Kingdom 2005 Range Rover Sport Supercharged Java Black

Scrumpy, thanks for the heads up, reflash done, very simple as you say but ALAS, not the fix!

Appreciate you taking the time to post, thanks

Rob

Post #543790 Wed Dec 20 2017 5:30pm
View user's profile Send private message View poster's gallery Reply with quote
RRSTDV8



Member Since: 12 Aug 2011
Location: Northamptonshire
Posts: 8971

United Kingdom 2012 Range Rover Sport SDV6 HSE Orkney Grey

Might be worth checking the compressor inlet pipework. If it's blocked/partially blocked then that will prevent the system from raising the vehicle.

From the book of lies:

Quote:
Compressor fault
Reservoir pipe air leak
Reservoir air leak
Gallery pipe air leak
Intake filter blocked/restricted
Intake pipe blocked/restricted
Air suspension intake silencer blocked/restricted
Corner valve stuck open
Pressure sensor fault


Edit: The inlet filter is behind the trim panel in the boot on the left hand side. The pressure sensor is in the valve block next to the compressor. 2012 SDV6 - it's missing a couple of cylinders
2008 TDV8 - it was a labour of love and is much missed

Post #543794 Wed Dec 20 2017 6:22pm
View user's profile Send private message View poster's gallery Reply with quote
Highside



Member Since: 03 Oct 2015
Location: Wirral
Posts: 7

United Kingdom 2005 Range Rover Sport Supercharged Java Black

RRSTDV8, thanks for the response.

Compressor doesn't start, don't want to admit it but looking like I need my second one within 2 years.

Looking at the AMK Upgrade!

Big Cry Big Cry

Post #543796 Wed Dec 20 2017 8:51pm
View user's profile Send private message View poster's gallery Reply with quote
GARYF123



Member Since: 03 Jan 2015
Location: leeds
Posts: 143

United Kingdom 2007 Range Rover Sport TDV6 HSE Stornoway Grey

Mine just had second AMK in 2 years! Had amber warning light so indy changed filter and discovered that one of the pipes from the compressor that goes inside the tailgate panel and sucks clean air in was missing, therefore sucking dirty air in and causing compressor to struggle! Best part of £700.00 later...

Post #543798 Wed Dec 20 2017 9:21pm
View user's profile Send private message View poster's gallery Reply with quote
RRSTDV8



Member Since: 12 Aug 2011
Location: Northamptonshire
Posts: 8971

United Kingdom 2012 Range Rover Sport SDV6 HSE Orkney Grey

Highside, it would still be worth checking that the pipes are clear. No point killing another compressor. 2012 SDV6 - it's missing a couple of cylinders
2008 TDV8 - it was a labour of love and is much missed

Post #543799 Wed Dec 20 2017 9:56pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2005-2024 Futuranet Ltd & Martin Lewis
RRSPORT.CO.UK RSS Feed - All Forums

Switch to Mobile site