RRSPORT.CO.UK
    Forum   Gallery   Shop   Sponsors
Home > Tips & Tricks > Installing Side Steps without taking wheel off?
Post Reply  Down to end
Page 1 of 1
 
adamm19830



Member Since: 21 Mar 2015
Location: Nottingham
Posts: 45
United Kingdom 2005 Range Rover Sport TDV6 HSE Bonatti Grey
Installing Side Steps without taking wheel off?

Hi all,

I received a set of side steps today for my RRS 2005 and I've just been to look at the job before I install tomorrow.
There are 2 small screws to take out near to the rear wheel that fixes the existing sill. These are a pain to access as there is minimal room between the screw and wheel.
Any suggestions on getting these screws out without taking the wheel off?

Thanks
Post #511778 Wed Dec 07 2016 9:11pm
View user's profile Send private message View poster's gallery Reply with quote
B9BS X



Member Since: 19 Nov 2014
Location: Birmingham
Posts: 420
United Kingdom 2005 Range Rover Sport Supercharged Java Black

These vids should help Thumbs Up



 RRS SUPERCHARGED, 22 INCH ALLOYS, JAVA BLACK, FULLY COLOUR CODED
EVERY POSSIBLE SOFTWARE UPDATE INCLUDING - BLUTOOTH UPDATE, SATNAV ON THE MOVE, CLOCK ON DASH, 3 CLICK FLASH, GEARBOX RESET, COMPRESSOR UPDATE AND SUSPENSION LOWERED,
BLACK CODE RE-MAPPED, AUTOBIOGRAPHY'D, NEW EXIDE BATTERY, NEW DENSO ALTERNATOR
Post #511781 Wed Dec 07 2016 9:20pm
View user's profile Send private message View poster's gallery Reply with quote
Gornal Hills



Member Since: 10 Nov 2014
Location: Dudley
Posts: 380
United Kingdom 2007 Range Rover Sport TDV6 HSE Cairns Blue

Hi, please don't laugh on how i did it Rolling with laughter i held a posi bit in a pair of mole grips @90 degrees , then levered a block of wood behind the grips for the pressure off the tyre..... and it worked a treat !! Thumbs Up Hope this makes sense Embarassed 2007, HSE, Cairnes Blue, Factory tints, Love it !!!
Post #511786 Wed Dec 07 2016 10:14pm
View user's profile Send private message View poster's gallery Reply with quote
adamm19830



Member Since: 21 Mar 2015
Location: Nottingham
Posts: 45
United Kingdom 2005 Range Rover Sport TDV6 HSE Bonatti Grey

Good idea gornal! I'll try that. My only fear is that as the car is 2005 the screws look rusty and may have seized! Sad
Post #511789 Wed Dec 07 2016 10:36pm
View user's profile Send private message View poster's gallery Reply with quote
Col



Member Since: 02 Sep 2012
Location: Hawkes Bay NZ
Posts: 4971
New Zealand 2013 Range Rover Sport Supercharged Autobiography Santorini Black

Gornal Hills wrote:
Hi, please don't laugh on how i did it Rolling with laughter i held a posi bit in a pair of mole grips @90 degrees , then levered a block of wood behind the grips for the pressure off the tyre..... and it worked a treat !! Thumbs Up Hope this makes sense Embarassed


Used very similar method when I fitted a pair except used a small ratcheting spanner instead of molegrips, worked a treat. Thumbs Up also replaced screws with stainless steel one's when refitted.

Ceers
Col
Post #511801 Wed Dec 07 2016 11:38pm
View user's profile Send private message View poster's gallery Reply with quote
Gornal Hills



Member Since: 10 Nov 2014
Location: Dudley
Posts: 380
United Kingdom 2007 Range Rover Sport TDV6 HSE Cairns Blue

" Good thinking Col" another good tip eh mate Thumbs Up 2007, HSE, Cairnes Blue, Factory tints, Love it !!!
Post #511835 Thu Dec 08 2016 1:13pm
View user's profile Send private message View poster's gallery Reply with quote
Gornal Hills



Member Since: 10 Nov 2014
Location: Dudley
Posts: 380
United Kingdom 2007 Range Rover Sport TDV6 HSE Cairns Blue

adamm19830 wrote:
Good idea gornal! I'll try that. My only fear is that as the car is 2005 the screws look rusty and may have seized! Sad

Hi adamm, give them a good shot of WD 40 mate and they will come out, plenty of leverage of the tyre Thumbs Up 2007, HSE, Cairnes Blue, Factory tints, Love it !!!
Post #511836 Thu Dec 08 2016 1:17pm
View user's profile Send private message View poster's gallery Reply with quote
Boothy



Member Since: 30 Mar 2017
Location: Herts
Posts: 59

Great tip
Post #523265 Tue Apr 11 2017 9:53am
View user's profile Send private message View poster's gallery Reply with quote
madtoro



Member Since: 22 Aug 2017
Location: Texas
Posts: 14
United States 

I just did this last weekend, the posi drive bit and mole grips worked fine for me too.
Post #540045 Fri Nov 03 2017 1:28am
View user's profile Send private message View poster's gallery Reply with quote
scousefly



Member Since: 24 Jan 2015
Location: sheffield
Posts: 248
United Kingdom 2011 Range Rover Sport 3.0 TDV6 HSE Sumatra Black
Just

done this and to be honest took the wheels off as it was easier. It also said 20 minutes a side which I think is complete Censored as everything is so fiddly it took me 3.5hrs but I took my time
Post #540050 Fri Nov 03 2017 7:39am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
<  Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2005-2024 Futuranet Ltd & Martin Lewis
RRSPORT.CO.UK RSS Feed - All Forums

Switch to Mobile site