I had a leak on my rrs, taken it to land rover and they have replaced the rear ace bar. After collecting the car the bake light on the dash came on. Had new pads a couple of months ago so no it wasn't them so checked brake fluid empty, filled the fluid and noticed a leak at the back near the first leak.
Do u have to disconnect the brakes to replace the ace bar? Or could the pipe of been damaged while replacing the ace bar?

Did they remove the body to do the job? 2x TDV6. SE and HSE. Both returned to sender with issues👀
TDV8 Sport HSE...... Gone. Loved it but it didn't love me!!
Now rolling in MY10 Fullfat TDV8 Vogue. Slammed it to go round corners🙈
Cruising daily #56 mph in a Volvo V8. 😱
Lots of other toys in the cupboard...😜

Not sure they said it was a 4 hour job, they have now reported back that the pipe are corroded, the check list that they gave me said every thing was fine, so they said it the pipe higher up

Pipes sit above Arb and out of site behind a shield. Noticed on mine when body off that pipes were rusty as was floor pan. Not good news as LR will take body off to do pipes, Indi will do it with body on.  2x TDV6. SE and HSE. Both returned to sender with issues👀
TDV8 Sport HSE...... Gone. Loved it but it didn't love me!!
Now rolling in MY10 Fullfat TDV8 Vogue. Slammed it to go round corners🙈
Cruising daily #56 mph in a Volvo V8. 😱
Lots of other toys in the cupboard...😜