Hi Lads,I,ve just took out map sensor(filthy)and gave it a good clean.I went a short run
to the shop (about 2miles)and all was fine,coming back after about 1mile l lost all power although
it did not stop,l pulled over and turned the ign off then started up again and away it went no probs
but l now have the engine managment on.Can anyone tell me whats going on and can l put the light off myself
PS I pulled the sensor out to clean it
Cheers Tommy

When you cleaned the map sensor did you push some gunk into the hole? Might pay to blast it with a bit of CRC. Also, there may be a possibility that the EGR valves are playing up - give each a light tap. Then start and shut down the engine three times - it takes three starts to clear the engine light. If no luck sounds like it needs to go on a diagnostic machine.

Cleaned out with WD40 and the eye of a needle,everything looked spotless.
I had the EGRs blanked off around 8month ago and car has ran minted since.
Anyway thanks for the quick reply
Cheers Tommy

KiwiRRS wrote:

When you cleaned the map sensor did you push some gunk into the hole? Might pay to blast it with a bit of CRC. Also, there may be a possibility that the EGR valves are playing up - give each a light tap. Then start and shut down the engine three times - it takes three starts to clear the engine light. If no luck sounds like it needs to go on a diagnostic machine.