I have the Autel AP200, which has been great. I know the GAP tool is the best but the Autel has served me well to this point.

I had a failed ride height sensor which I've replaced and now need to do a calibration.
I can access the correct menus and get into the process but each time the measurement values fail.

Start in Normal mode with heights all over the place >
Step 1 - enter the measured current values for each corner (mm) > ok
- The car raises to extended and then returns to "normal height", all 4x corners more or less 460mm
Step 2 - its asks to measure again, so add in 460mm for each corner (mm) > ok
- The car raises to extended and then returns to messed up height and states its failed

For a pass condition all 4 wheels must have a height calibration error of 3mm or less.
Suspension height calibration errors are
front left is 1 mm,
front right is 6 mm
rear left is 0 mm
rear right is 3 mm

There are form posts saying to the calculate values it wants and add them in, but I'm not sure how to work out what it wants.

Has anybody done this with Autel or another similar non Gap Tool..? 2012 SDV6 HSE Lux

Have a look in the disco3 forum.

Few posts on that subject