Does anyone know the size of the battery +ve clamp screw on the L494. I have decided to put a permanent feed fag lighter socket in the boot to run my Ctek. I have a comfort connector under the front grille, but by putting one in the boot it allows me to hook it up no matter which way the car is in the garage (some might say I too much time on my hands )
Anyway would like to get the screw size before removing the full size spare with that well engineered lifting device supplied then I would make sure I have the correct electrical eyelet

10mm

Thanks for that, now to get that wheel out

Not sure it helps in any way but the nut shown here (HN1) is 8mm thread diameter. Is that 10mm thread dia. or nut size which would be 6mm thread dia.




Cheers
Col

After much again, getting the spare wheel removed. The battery +ve is 10mm nut & M6 thread. Job done, now have permanent fag lighter socket in the boot . Mounted it in the recessed section on right hand drivers side