For sale is a decat pipe to suit a RRS

Brand new, never got around to fitting it

Made from 409 grade stainless steel this down pipe for the TDV6 removes the restriction of the original CAT.

Click image to enlarge

what is it like to fit mate

Not fitted it myself obviously, but would of fitted it DIY after looking at the guide below

Hope that helps

Thanks

Ade

Quote:

okay guys, this is quite a simple fitting

first you have 3 15mm nuts which you pre apply copious amounts of free off spray to allow safe removal with no nasty broken studs!!

[URL=]

Click image to enlarge

[/URL]

you can see this is tight on room, but 1/2" drive with universial and fixed HEX sockets and a speed bar to loosen and then out the inboards come.

the outboard one, you can loosen and then from the wheel arch you can with a 15mm ring spanner remove it with no real problem.

this then moves on to the rear box joint which is imperial in socket size on the clamp.

this is undone fully to allow a figure of 8 wiggle to be setup between the pipes across the joint to ease off the joint and allow the pipe to slide out. as shown

[URL=]

Click image to enlarge

[/URL]

this then allows us to now move on to the hanger that is all that is left keeping the front cat pipework attached to the car.

[URL=]

Click image to enlarge

[/URL]

NOW!!!! you have 2 options

you can remove the main rear gearbox chassis member to release the old front CAT pipe from the car,

OR

you can cut the pipe behind the CAT to drop out the 2 parts!!

[URL=]

Click image to enlarge

[/URL]

the new one fits into the car with the chassis member in place so depends if you want to keep the old CAT pipe for nostalga!!

refitting is a case of copperslip the studs on the turbo, fit new gasket, and mount the new front pipe flange and fit the 3 15mm nuts and tighten.

then wiggle it into the rear system pipework and tighten the clamp, refit the front hanger,

slide from under the car and breath a sigh of relief!!!!

Tidy up, and wash up, go for a non restricted drive and even more power released

Admin note: this post has had its images recovered from a money grabbing photo hosting site and reinstated

They are an to fit

2.7 or 3.0 tdv6? ? 2010 RRS HSE 3.0 tdv6 2010MY
2012 Audi a5 2.0 tdi s-line
2005 Discovery 3 tdv6
2009 audi a4 2.0tdi saloon
2007 Audi a3 1.9tdi sportback
2004 Navara Double Cab
1996 Shogun 3.0 v6
1984 Landrover 90 2.5d

Sorry, forgot to mention its for the 2.7

Thanks

Ade

hows about 90 quid delivered mate

Sorry. I may be able to trim a bit off by finding a cheaper courier, but not that cheap I'm afraid

£100 delivered

Thanks

Ade

no worries mate just thought i would ask, martin at bellautos said its a garage job to fit it so need to allow for that mate

Will it pass the mot with this fitted

As long as the emissions are ok it will, but cut the old cat housing off your old one and weld it into place as the cat is now a visible check item on the mot

Les

My wifes Disco passed an MOT this month with one fitted, and there everyone over on the Disco3 forum who has one fitted have had MOT's within the past couple of moths with no problems