RANGE ROVER SPORT DOOR PANEL SUPERCHARGED DECALS

does anybody know how are these fitted?

http://cgi.ebay.co.uk/RANGE-ROVER-SPORT-DO...m153.l1262

They pop out really easily, just lift from the right.

10 second job

Don't they come ready fitted when you buy a Supercharged car?

Another SW wrote:

Don't they come ready fitted when you buy a Supercharged car?

... ...

(I`m allergic to green badges... plus I don`t look at it that deeply, I`m not trying to pass my TDV6 off as a SC RRS, it`s that I have a silver and black RRS and as there is a silver and black badge available, its a quick and easy way to enhance the theme. )

L L

JUST kind of push them out with my fingers ????

Thankyou so much , ur amazing.

I think ive been done up with the dacals I brought though... Theyre smaller than my ones and dont really stay in securely...

flight wrote:

I think ive been done up with the dacals I brought though... Theyre smaller than my ones and dont really stay in securely...

Yes they are metal and I think you might be right...
They seem to be that size... and they have big round things on the end of the plastic thingy...

I have also changed my badges to black and had the same problem. The badges are different depending on whether you have a supercharched sport or non supercharged sport. You have either been given supercharched door badges or maybe steering wheel badges. They do not fit in the holes of non supercharged models as they have metal backing. They are also slightly smaller.

I have seen some black ones for sale that are compatable on ebay with the plastic backing hooks as shown in AndrewHG2's photos. I just ended up trimming the metal and putting them on with superglue. Maybe get the compatable ones later as they fit flush and click in.

I've replaced all the green badges in and outside of my TDV8. The s/w and interior door trim badges are made of Tin (with a clearcoat/plastic laquered front).

Dead easier job - just be careful when removing the steering wheel badge!

do u think it would be a good idea to use a hair dryer on the steering wheel badge to make the glue soft so i can get it off??

Carefully drill small hole in centre. Put self tapping screw in and pull gently with pliers to release the metal prongs that hold the badge on.

Hairdryer won't help. Might damage your wheel TDV6 - gone
TDV8 - gone
Audi Q5 3.0 Tdi Sline wef 6/11/10

Agreed. There isn't any glue on the steering wheel badge, it's just held in with tin prongs (4 in total). Slowly and carefully prise it out. The new one will need to be stuck on (the prongs are cut off) with glue or 3m. Try and get a wafer thin tape otherwise it will look stuck on.

These are my door card badges fitted (they just pop in)

 Range Rover Sport HSE DYnamic SDV6 Velocity blue 2020 MY
Range Rover sport HSE Dynamic P400e Silver
Range Rover Sport 3.0 SDV6 HSE Dynamic 2016 MY
Range Rover sport 3.6tdv8HSE 2007 Gone
Range Rover sport 2.7tdv6SE 2005 Gone
Range Rover sport 2.7tdv6SE 2007 honey
Range rover Vogue 2005 4.4 - GONE and missed
BMW 535d M sport 2006 - GONE not as missed
BMW X5 4.4 2004 sport - GONE

thank's very much guy's