Hi all, as the tittle says I'm looking to any of you who have changed the front discs and pads on their RRS S/C.
I Live in wolves but my wives car needs to be done and this weekend and its stuck down in Buckinghamshire. I got replacement discs and pas from AF due to the recommendations on this site. I've limited room in my car due to my two dogs also making the journey with me so would be very appreciative of the information.
Any tips would be welcome.

Thank you. Steve RRS 2006 supercharged
BMW 320d sport touring
Yeti ASR 5
Charge blender hardtail
Oshea mini mal board

Take a look at my brake bible (in my signature below) list of tools in there.

It doesn't cover front brembos (I assume you have as its a s/c) but there's another post on here on how to change brembos also. Bodsys Brake Bible
Software Updates Contact me
RRS Timed Heat/Remote kits - Contact me
BAS Engine Re-maps/ EGR Blank EuIII and EuIV
Clock On The Dash/ SNOTM /3Flash / BT Update /Service Reset/Error Codes read\ Gearbox Reset
See it HERE

Hi bodsy just came across a post regarding brakes and noticed that you mention on other subjects about phone book over bluetooth and sat nav on the move, i have 2007 rrs with sat nav, tv and dvd, rear screens would like more info on the phonebook updates, live close to wolves so can travel, thanks

Sent you a PM sinbad  Bodsys Brake Bible
Software Updates Contact me
RRS Timed Heat/Remote kits - Contact me
BAS Engine Re-maps/ EGR Blank EuIII and EuIV
Clock On The Dash/ SNOTM /3Flash / BT Update /Service Reset/Error Codes read\ Gearbox Reset
See it HERE

Thank you Bodsy nice one. anybody know the torque settings for brembo callipers? RRS 2006 supercharged
BMW 320d sport touring
Yeti ASR 5
Charge blender hardtail
Oshea mini mal board

I think (95% certain) that the carrier bolts on my front Brembos were tightened (by myself) to 215 Nm. I think the rears were tightened to 150 Nm.

Oh yes, get new carrier bolts before you tighten the calipers back into place. On my rear TRW calipers I broke a carrier bolt when re-tightening. Pain in the rear end to remove!

edit:

Re-read the post that I followed, describing the procedure, and in fact I tightened the bolts to 250 Nm because that's the limit on my torque wrench. However 275 Nm was advised. Recently bought a 2007 RRS HSE TDV6 for a Pimp-My-Ride-Project.
DONE: Meduza front bumper, AB rear bumper, AB tailpipes, calipers repainted, rear upper tailgate upgrade, side steps, AB front grille, AB side vents, rear LED lights, clear side repeaters, integrated daytime running lights, LED headlights.
TO DO: color code sills and pillars.

Last edited by tanloverluke on Wed Nov 19 2014 6:29pm. Edited 2 times in total

Bodsy wrote:

It doesn't cover front brembos (I assume you have as its a s/c) but there's another post on here on how to change brembos also.