Evening all,

i managed to hit the door mirror on passenger side hard enough to break the glass and leave it hanging out.

So, bought new glass and fitted but its sortof floppy and wont adjust enough for me to see down side of car.

I'm guessing it needs a new motor/ring thing at about £25 but no idea how to swap out.

Any one know

Anyone

You mean how to change it?

there is a torx bolt in the middle and than just un-clip it

should have one kicking around if in need

Nah, mines broke and floppy (the mirror ) but I've just learned to live with it. I think it's been broke because you have to put quite a bit of pressure on the glass to get it to click in. I don't know If the ring thing can be replaced but would also be interested to know. Range Rover Sport HSE DYnamic SDV6 Velocity blue 2020 MY
Range Rover sport HSE Dynamic P400e Silver
Range Rover Sport 3.0 SDV6 HSE Dynamic 2016 MY
Range Rover sport 3.6tdv8HSE 2007 Gone
Range Rover sport 2.7tdv6SE 2005 Gone
Range Rover sport 2.7tdv6SE 2007 honey
Range rover Vogue 2005 4.4 - GONE and missed
BMW 535d M sport 2006 - GONE not as missed
BMW X5 4.4 2004 sport - GONE

Yes it can be replaced

and it does not broke when fitting a glass
it did when mirror was hit (hard )

yes it broke when hit HARD

yeah i wanted to know how to change it , 1 torx screw sounds easy enough even for me.

Iv'e got a bit of foam jambed in behind it to keep it still and at the right angle.

Adigorn could be interested if you have one knocking around, let me know how much you want if you find it

Hoppy, the ring thing is attached to the motor afaik, mines all floppy too without the foam

Mister B i am sorry but i am forced to withdrawn my offer
i have found it and its drivers side
so no good for you

Hey no probs, the foams still good

Seriously though, thanks anyway, and you have reminded me that they are handed (forgot that point ) if i decide to look at fleabay

Did you figure out how to change the motor ? I need to replace mine - have the spare. I see a youtube on how to remove the mirror glass itself. Then the motor is just one TORX screw ? what about the wiring connector ? Do you need to remove the door pillar trim/tweeter and pull wires ? Or is the connector on the outside of the door in the black mirror body ?

Alpaca

can't tell you i'm afraid, i still have a bit of foam stuck behind it